To Simulate the IEEE 802.3 Ethernet project in OPNET has ned to follow the series of steps that contain the configuration of network model which involves the Ethernet switches, hosts, and links which observe to the Ethernet standards. here is an information on how to Simulate IEEE 802.3 Ethernet projects using OPNET:
Step-by-step IEEE 802.3 Ethernet projects using OPNET:
- Set Up Network Topology
- In the Object Palette in OPNET to choose the Ethernet workstations, switches, and routers required for the topology.
- To select the network topology like a star, bus, or ring and order to the Ethernet nodes of hosts, workstations, and consequently to switches.
- Add Ethernet Links
- To utilizing the Ethernet links to join the network devices to according to the IEEE 802.3 standard.
- To choose the connection of speed for instance 10 Mbps, 100 Mbps, or 1 Gbps dependent on the Ethernet variety they are replicating such as the Fast Ethernet, Gigabit Ethernet.
- Configure Ethernet Properties
- For every device to attach the setup of Ethernet-specific metrices:
- Data Rate: To choose the correct speed for every communication and device.
- Duplex Mode: Require the half-duplex or full-duplex terms on the Ethernet variant. Full-duplex mode allocate the continuously transmission and receiving the however half-duplex permits only one operation at a time.
- MAC Addressing: OPNET instinctively allocates the MAC addresses nevertheless assure which every device has to a exclusive of MAC if desirable for the simulation.
- Set Up Traffic and Application Configuration
- State the kind of traffic we want to replicate over the Ethernet network like FTP, HTTP, email, or voice traffic.
- In the Application Configuration object to specify the applications of replicate are counting their traffic features.
- To utilized the Profile Configuration to allocate the applications of the Ethernet in workstations of permitting the various kind of traffic flows such as high bandwidth, low latency.
- Configure Performance Metrics for Analysis
- To permitting the data collection of main Ethernet performance parameters:
- Throughput: To evaluate the total data communicated along the Ethernet network.
- Collision Count: In half-duplex mode to calculate the collision rates in the network.
- End-to-End Delay: To verify the latency for packets traversing the Ethernet network.
- Utilization: Observe the bandwidth utilization of every Ethernet link.
- Run the Simulation
- To configure the replication of runtime parameters terms on by what method long we need to the model running.
- To estimate the replication and observer the real-time performance of the Ethernet network to comprehend network behaviour, collisions, and delay.
- Analyse Results
- To utilizing the OPNET’s Analysis Tools to assessment of brief procedures:
- Collision Statistics: To Assess the frequency of collisions if used the half-duplex.
- Traffic Received and Sent: To Checked the data on packet and byte counts.
- Delay and Throughput Analysis: To analyse in what way effectively the Ethernet network switches the setting the traffic.
- According the insights of we could adjust the setting like as communication speeds or traffic patterns, and re-run the replication.
In this manual we offered Simulation IEEE 802.3 Ethernet projects using OPNET tool. It considers the network topology then configure the Ethernet projects using OPNET to run the simulation results and reports. we offer the tools to execute this simulation. If you want further information to regarding this project, we will clarify it in another manual.
phdprime.com team specialize in managing Ethernet switches, hosts, and links, assuring you of our capability to successfully complete your project with punctual delivery. For the simulation of IEEE 802.3 Ethernet projects utilizing the OPNET tool, please contact us. We offer customized research services alongside high-quality paper writing. Trust us to enhance your network performance.
